Humanity HM-PH60 is designed for 4E1, 4Ethernet and 1-60 telephone over one fiber line.

The 1-60channel telephone can be customized to other services.

• 1.5U 19inch
• Thunder-protection
• 24hours aging for stable performance.
• The 60FXO/FXS can be customized to other services such as 2/4wire E&M, RS232 data, magnet phone etc., The required services need to state when in order, please feel free to contact us if there is such inquiry.

Optical	E1
Default with dual fiber, single mode, 40km, 1310nm, FC Optical module is option when in order. Rate: 150Mbps	4E1 Coding: HDB3 Impedance: 75Ω or 120Ω option Connector for 75Ω: DB37 connector Offer DB37/BNC adaptor for 75ohm and DB37/RJ45 adaptor for 120ohm.
Fast Ethernet	Telephone(FXO/FXS/hotline)
4 Ethernet interfaces with VLAN Share 10/100M, MDI/MDIX, full/half duplex Connector: RJ45 MAC address list capability: 1024 Frame length: 64byte~1916byte Support stream control	Connector: RJ45 Impedance: 200Ω+680Ω‖0.1uF Frequency character: 300-3400Hz（-0.6-+3dB）Weighted noise: ≤-65dBm Interface loop resistance: ≤1800Ω
Low speed Ethernet(option)	2/4 wire EM(option)
Connector: RJ45 Bandwidth: NX64Kbps，N=1-30 MAC address list capability: 1024 MAC address list aging time: 5 minutes The minimum frame length: 64byte~2024byte VLAN: support VLAN transparent transmission	Input impedance: 600Ω Tolerance common-mode voltage in audio wire: 300V CMRR: better than 55db.
Magnet phone(option)	RS232(option)
Connector: RJ45 Input impedance(normal non ringing status): 600Ω Return loss: 40dB Frequency: 300-3400Hz（-0.6-+3dB） Ring voltage: ≤ 90V Ring frequency: 20Hz to 90Hz	Connector: RJ45 Transmitting output voltage: ±15V Receiving input voltage: ±15V   The maximum rate of transmitting and receiving: 38.4Kbps
RS485(option)	Console management
Connector: RJ45 Receiver input sensitivity: maximum ±200mV Receiver output current, IO: ±10mA The maximum transmitting and receiving rate: 38.4Kbps	Connector: RJ45 for monitor and configuration
DIP switch	Power&Environment
Switch1: set VLAN Switch 2: set local/remote alarm Switch 3: set timing	AC, DC, or AC+DC power Working temperature: 0 ~ 70℃ Relative humidity: ≤90%(25℃)